Web flasher not showing firmware

Recurrent H/W and software problems
Post Reply
lyizb
Posts: 113
Joined: Fri Feb 12, 2021 8:23 pm
Has thanked: 49 times
Been thanked: 31 times

Web flasher not showing firmware

Post by lyizb »

I'm trying to reflash a Wemos D1Mini currently flashed with 1.37 Beta 1. In the web flasher, I click on connect and select the port. It says connected successfully, but I don't get the options to select the firmware and set the configuration.

If I try with an ESP32-S2Mini, I connect and get the expected choices.

What am I doing wrong?
User avatar
cicciocb
Site Admin
Posts: 2195
Joined: Mon Feb 03, 2020 1:15 pm
Location: Toulouse
Has thanked: 470 times
Been thanked: 1461 times
Contact:

Re: Web flasher not showing firmware

Post by cicciocb »

Connected successfully just mean that the serial port is open (I'll change this message because is very toxic :twisted: )

Try to hold the boot button on the module while you connect it with the PC
lyizb
Posts: 113
Joined: Fri Feb 12, 2021 8:23 pm
Has thanked: 49 times
Been thanked: 31 times

Re: Web flasher not showing firmware

Post by lyizb »

The D1Mini doesn't have a boot button (as on the S2Mini), just a reset button. Flashing from the application (not the web) did not require that--but I'll pull pin 0 to ground when powering up and I'll see what happens.

That worked. D1Mini flashed Ok and reported its old fixed IP address. I connected to it and the original files are there. Thanks.
Post Reply